CMIT 350

Name:_______________________

Edit this file and BOLD your answers.

Using JimSim again.  

Edit the config files so that no IP addresses are assigned and
the routing protocol is not running.

Assign IP addresses to the serial link between routers 1 and 2.
The S0 is the DCE end of (simulated) back-to-back routers so
it needs a clock rate.
Bring up the 5 Ethernets of the diagram below by assigning whatever 
networks and IP addresses you want.
Note that unlike the JimSim diagram, Routers 1 and 2 are NOT 
on the same Ethernet, their E0's are on two different LANs.
Subnetting is not required.  I suggest you use six class C private nets.
Do whatever else is necessary so that all routers can ping all the
interfaces of all the other routers.
The simulator is buggy and so EIGRP doesn't seem to work with these
roll-your-own network topology, so static routes will be needed.
Note that the simulator does not support the "outgoing interface"
style of the ip route command, only the "next hop" style.

Write the addresses  of the 8 interfaces, using prefix notation:
          ___________________________________________
          |                                         |
         S0                                         S1
      Router1               Router2              Router3
    e1       e0            e0     e1            e1     e0
    |         |             |      |             |      |
 ----         ----       ----      ---------------      ------



Paste the entries of the routing tables of the three routers:
Router 1:


Router 2:


Router 3:



Paste the traceroute from R1 to R2's E0:



*************************
Warning: JimSim allows network aned broadcast address to be assigned to
an interface!

eigrp on roll-your-own nets doesn't work???

other Serials don't work.